averzwyv
Newbie
Anyone have any experience with sharpening their flat blade or latex sword in different ways?
I'm looking for feedback on felt impact and edge durability.
Ie. Boffers are round, made with piping foam, and unless hard from too much tape, tend to spread the impact over a circular contact patch.
The current flat blades that I am making, I have sharpened to 3/8" from a 1" blade thickness, with a edge angle of roughly 30degrees.
I'm considering taking this down to a 1/4" or less to create a softer impact as there will be less material thickness to resist deformation. However, there will be correspondingly less contact area.
Has anyone messed with this at all?
I'm looking for feedback on felt impact and edge durability.
Ie. Boffers are round, made with piping foam, and unless hard from too much tape, tend to spread the impact over a circular contact patch.
The current flat blades that I am making, I have sharpened to 3/8" from a 1" blade thickness, with a edge angle of roughly 30degrees.
I'm considering taking this down to a 1/4" or less to create a softer impact as there will be less material thickness to resist deformation. However, there will be correspondingly less contact area.
Has anyone messed with this at all?